Forum Replies Created

Viewing 3 posts - 1 through 3 (of 3 total)
    • werner58
      26 August 2020 at 1:10 am #267

      I give up with the FIR Designer EX and the FIR Designer Lake Module. It’s not what I wanted.
      Can you give me a guarantee, that FIR Designer M supports the Lake XP1, XP2, XP3 modules?
      If yes, I upgrade from FIR Designer EX to FIR Designer M. What will be the deal for that?
      Best regards.

        werner58
        25 August 2020 at 7:13 pm #265

        >>The Lake FIR 3-way module has specific sample rate requirements for the output channels. It sounds like you might be using the same sample rate for LF and HF. The allowed combinations are 48|24|12 kHz or any combination of 24 and 12 kHz.

        Yes, the different channels had all the same sample rate of 48Khz. I will check it out with different sample rates. What is the best distribution for the sample rates? Lower sample rate for the low channels and higher sample rate for the HF cannels?

        >>I think you are referring to the Lake XP 1, 2, 3 and 4 way modules in Lake Controller 7.0. I’m surprised FIR Creator EX could load something into these. Whilst the internal Lake API might pass some data, we don’t actually support the XP modules from FIR Creator EX and FIR Designer; only from FIR Designer M. The modules are far more complex than the Lake FIR 3-way module and their multi-channel capabilities are more easily handled by FIR Designer M.

        What obviously means that I’II has to update to the very expensive FIR Designer M to be able to work with the XP1, XP2,… Lake modules.

          werner58
          20 August 2020 at 3:24 am #263

          Hello EA support team

          My config. is FIR Designer EX V1.48 and Lake V7.0 (Plugin and Fir3Modul is installed)
          The point:
          I can design a 2W module in FIR Designer-EX and load the LF Filter and HF Filter to the emptyFir3Way unlocked module.
          Loading the LF Filter in way 1, quite with a green check ok.
          Loading the HF Filter brings up error 2 and after refreshing a green check ok to.
          A control measuring of the 2w speaker shows me the right response for the LF way, but the HF way cuts of too early (5K instead of 15K) and the phase is not correct.
          Loading the same LF/HF filter Setup in a LAKE FX3 module works perfect and gives me important additional setup opportunities. But it’s a bit senseless to spend 3 of 4 Lake DSP cannels for a 2W Speaker Setup.
          Question:
          -Can you give me a hint, where the Problem with the EA 3w csm File is?
          -And I wish (more important) that the Lake FX1 and FX 2 File also work together with FIR Designer EX.
          Please can you do this???

          Thanks for your answers

        • |
        Viewing 3 posts - 1 through 3 (of 3 total)